Myers expands its successful line of sump, effluent and sewage pumps for plumbing contractors.
Discharge: 2” (50.8 mm) NPT vertical discharge: The MWS9 | 3” (76.2 mm) NPT vertical discharge: The MWS39
Power Cord: Single Phase: 20’ UL/CSA Listed. 3 wire 16-3 SJTW-A/SJTW water resistant cord with integrally grounded three-prong plug. Three Phase: 20’ UL/CSA Listed. 4 wire 16-4 SJTW-A/SJTW water resistant cord.
Impeller: Cast Iron Two-Vane Semi-Open Vortex
Volute Case: Cast Iron
Motor housing: Cast Iron
Shaft seal: Primary: Mechanical type 21 or equal, Buna-N elastomers, silicon carbide seal faces, stainless steel metal parts; Secondary: self-lubricating energized nitrile lip seal
Acceptable pH range: 6-9
Motor: 1, 1-1/2 and 2 HP, 1725 RPM, 230 Volt, single-phase, or 208- 230/460 and 575 volt three-phase, 60 Hz. Oil-filled. PSC with thermal overload with built-in thermal overload protection with automatic reset and permanent split capacitor on single-phase only.
Min. Basin Diameter: Simplex: 18" 457mm Duplex: 30" 762 mm
Intermittent liquid temp: 130°F 55°C
Solids handling: 2" 50.8mm
Operation: Tethered:: Automatic Float Switch or Non-Automatic (manual) model available.
Shut-off head: 54' 16.5m
Capacities: 235 GPM 889 LPM
Applications: Sewage and Wastewater Removal and Transfer, Sump Drainag
HR Series Jet Pumps provide reliable service for many residential homes and farms, as well as commercial and industrial applications.
Myers® powerful high head 5 HP self-priming pump delivers strong dependable performance for the most demanding jobs. The heavy duty 84JM motor, brass impeller, and large capacity rugged cast iron pump end deliver reliable and continuous high performance service.
The SRA-125 Rail System is tailored to your specific hydraulic needs for low pressurized sewer system requirements.
Package includes your choice of a 2 HP submersible grinder pump, SRA rail system, control panel, three floats and a polyethylene basin available at various depths.
Liftout rail system provides ease of installation and removal for the centrifugal grinder pumps. The SRA System uses a cast iron discharge elbow with integrated ball check valve. Also available with spark-proof rails for hazardous locations. Available with Polyethylene or Fiberglass basin.
Myers products are sold through a network of thousands of dealers throughout North America.
Our support team is here to help with online chat, by telephone, or leave us a message below to get detailed information that suits your specific needs.